|
Test Number Two - Access from the PC's real IP address?
If you are this far, then you
have verified that you can see the image below when you use
127.0.0.1:8000 in your browser.
If you do
NOT see that
page when using 127.0.0.1, go to
test 1
This next test is almost
identical, except now we're going to use your PC's "Real"
private IP
address. Please follow the instructions below
Write Down Those Numbers!
On your screen, your numbers will most likely be different than
mine.
A typical config will
probably show an IP address of 192.168.1.100 and a Default Gateway
of 192.168.1.1
Look at the line that
says "IP Address . . . . . . . . . . ."
That is your
computer's current IP address. To run the next test, you need to
enter that into your browser like this:
http://xxx.xxx.xxx.xxx:8000
(Where xxx.xxx.xxx.xxx
is the IP address your computer shows you)
Enter that into a
browser now!
What happens? If
you're lucky, you'll see the following:
If you see that page, proceed to
Network Configuration
If you do not see that
page, make sure your SHOUTcast DNAS is running! (Check for the icon
in your system tray). If it isn't running, launch it Start... Programs...
SHOUTcast DNAS... SHOUTcast DNAS (GUI) and try the test again.
If it is running, you
have software on your PC that is blocking ports. Nobody but you
knows what is running on your PC.
If you have a router...
If you have a router (LinkSys, D-Link, NetGear etc) or a DSL Modem,
you can probably safely disable PC-based firewalls. The router
and/or modem is a firewall. To turn off the built-in XP firewall, go
to properties of your Network Connection, and find the tab that
deals with the firewall. Turn it off.
1) Reboot.
2) Restart DNAS
3) Restart Winamp
4) Repeat all steps on this page (in case your PC's IP address
changed)
If it still doesn't
display the page above, you have other software to disable. Common
products include:
-
Cybersitter
-
Norton Internet
Security
-
ZoneAlarm
-
... Many more
Uninstall these
products, then...
1) Reboot.
2) Restart DNAS
3) Restart Winamp
4) Repeat all steps on this page (in case your PC's IP address
changed)
If you do not have a router
If you do not have a hardware firewall, then simply
disabling software firewalls is not an option. You will need to
configure the software you are using for security, and/or the
built-in XP firewall, to allow TCP Port 8000 and 8001. Consult the
software help files and the manufacturer's website for more
information. Once you have configured your software firewall...
1) Reboot.
2) Restart DNAS
3) Restart Winamp
4) Repeat all steps on this page (in case your PC's IP address
changed)
By now, either it
works or you do not have the technical expertise to proceed. If
you're stuck, it's time to call in a friend, family member or
neighbor to help you.
If you see that DNAS page,
proceed to
Network Configuration
|
